If the Firmware Version of the sensor is not up-to-date (the number appears in red), select the button to upgrade the Firmware Version.
#SCHICK SENSOR INSTALL#
Verify in the Upgrade Utility that the Sensor Module Firmware Version is also up-to-date (the number will appear in green). For the Schick Elite or Schick 33 Sensors the calibration files will install automatically when the software is launched. Connect either the Elite or the Schick 33 Sensor to the Schick USB 2.0 Module.if you update one computer to the 5.16 driver and update firmware/ FPGA of the module, for this module to be compatible in another room, it must be on the 5.16 driver. NOTE: if this module is used in other rooms, you must update the rest of the rooms to the same driver.Once completed, select the FPGA button to update. If the Firmware and FPGA Versions are not up-to-date (the numbers appear in red), select the button to upgrade the Firmware Version first.Verify the Firmware Version and FPGA Versions for the USB Interface are up-to-date (the numbers will appear in green).Open the Upgrade Utility (Start | All Programs | CDR DICOM for Windows | Upgrade Utility).Once the installation is complete, plug the Schick USB 2.0 Module into the A-to-B USB Cable, and then the USB Cable into the back of the computer tower.Follow the prompts to install the driver.In the extracted folder, right-click the CDR Elite Setup and select Run as administrator.then right-click again and select Extract All. Once the folder has downloaded, right-click the folder and UNBLOCK.Download the Schick USB 2.0 Module driver from Schick's Website, Select the Schick 33 and Elite Sensor Drivers.
0 kommentar(er)
